Skip to content
Specialist Viking Appliance Repair in Los Angeles
Error Code

Viking Dishwasher 2-1 Error Code

Code 2-1 flags a pressure sensor signal that reads low, as if it were disconnected.

Content status: Verified

Error code 2-1
Appliance Dishwasher
Quick answer

Code 2-1 flags a pressure sensor signal that reads low, as if it were disconnected.

Model compatibility: Viking reuses codes across series and model years, so 2-1 may mean something different on another appliance or generation. Confirm this against your model’s documentation and record your full model number before acting.

Plain language

What this code means

Viking lists 2-1 as a pressure sensor disconnect, with the sensor reading out of its normal range on the low side.

What 2-1 stands for

Expect Pots/Pans to blink 2 times, then Normal Wash once. The manual title is pressure sensor disconnect error.

Why the sensor matters

Where a pressure sensor is fitted, the control depends on it for the water level during fills and drains. Should its output sink beneath the expected band, the control stops trusting it and posts 2-1. Put simply, the complaint is about the electrical signal rather than about how much water is actually in the tub.

Three entries, nothing more

  1. Be sure the sensor is correctly connected.
  2. The sensor could be faulty.
  3. The wiring harness of the sensor could be faulty.

These come from the manuals for VDB451/FDB451 and VDB325/VDB450. Viking publishes no ohm value, reset procedure or owner step, and neither the FDB301 group nor the VDB200 manual includes the code.

Where else this sensor shows up

Level codes 2-3 (low), 2-4 (high), 2-5 (abnormal change) and 4-5 (fill too fast) all rely on the same part.

Your part in it

The sensor is mounted within the dishwasher and wired to a board that carries line voltage, which puts the connection check in a technician’s hands. What helps is a timeline: did 2-1 begin once the machine had been moved, repaired or opened up?

Related codes

  • 2-3: low water level from this sensor.
  • 2-4: high water level from this sensor.
  • 1-1: moisture sensor with a disconnected-style reading.

Viking dishwasher repair in Los Angeles

Phone (310) 692-1112 in Los Angeles with 2-1 and the model number. The dishwasher repair page describes the appliances we work on.

Source: Viking Preferred Service Manual SMK-0005; SMK-0003

Important safety warning. Do not attempt repairs involving electrical components, gas, water lines, refrigerant or sealed systems. Unplug the appliance if it is safe to reach the outlet, and leave internal diagnostics to a qualified technician.

Seeing this code on your Viking appliance?

Book a specialist visit for a clear estimate and approval before any repair.

Book a repair

Tell us what’s wrong — we’ll take it from there

Share a few details and we’ll confirm an appointment. Prefer to talk? Call us and we’ll help right away.

Hours Mon–Sat: 8:00 AM – 7:00 PM
Service area Los Angeles and selected surrounding Southern California communities

Request your repair

Use the secure scheduler below to request your appointment.

Call Book a Repair